Reverse osmosis systems consist of a series of tubes including lots of spiral wound membranes. These tubes are mounted on high pressure containers. The membrane stack consists of two quite long semi permeable membranes with a net in between, sealed along the sides. This can be wound up in a spiral tube with another net to separate the outside of the stack. The coil winding supplies a huge surface area for transport. Between each membrane layer is a net separator that enables pure water to flow without obstacles. Water is driven through one end of the coil cylinder and out through another end. The resulting pressure pushes the water through the membrane and accumulates in the space between the membranes. Pure water flows around the coil and is gathered in the center of the pipe. The best reverse osmosis system consists of a holding tank with level controls that feeds the reverse osmosis pump. It additionally includes a reverse osmosis water storage tank with level controls and duplex pumps for water pressurization. High pressure gauges are fitted on the reverse osmosis end product pump and the concentrate pump. Pressure switches are fitted on the reverse osmosis feed and flow screens on the concentrate, permeate and recycle stream. The cleaning cycle is automated in bigger systems with automatic valves. Industrial Reverse Osmosis System Pretreatment is required for all systems which were created to remove suspended solids, water hardness, chlorine and other oxidizers. Deposits of calcium and magnesium can stop up the membrane. Substances or water softeners are added to the water to keep the solids in suspension. A water softener is used to remove the hard ions and replace them with sodium. Comments are closed.
|
ArchivesCategories |